Dear Johannes,
The mode check plot in default covers region of the estimated parameter psi from 1 to 3. Could I ask if there is any way to extend the mode check plot region so that I can see psi from 0 to 3 ?
Thanks in advance.
Kind regards,
Huan
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
extend mode check plot region
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
extend mode check plot region
by ZBCPA » Thu Dec 22, 2016 1:59 am
- ZBCPA
- Posts: 101
- Joined: Sat May 16, 2015 4:15 am
Re: extend mode check plot region
by jpfeifer » Thu Dec 22, 2016 8:01 am
See the manual on
- Code: Select all
mode_check_neighbourhood_size
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 6 guests