Dynare forums

Posted: **Thu Dec 22, 2016 1:59 am**

Dear Johannes,

The mode check plot in default covers region of the estimated parameter psi from 1 to 3. Could I ask if there is any way to extend the mode check plot region so that I can see psi from 0 to 3 ?

Thanks in advance.

Kind regards,
Huan

Posted: **Thu Dec 22, 2016 8:01 am**

See the manual on

Code: Select all: mode_check_neighbourhood_size

Dynare forums

extend mode check plot region

extend mode check plot region

Re: extend mode check plot region