Dynare forums

Forums for asking questions, posting comments and uploading examples related to Dynare

Skip to content

two country model- BK condition not verified

This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location where you will have to reset your password.
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
Topic locked

two country model- BK condition not verified

Postby zheyizhu » Thu Jan 26, 2017 12:21 am

Hi all,
I am currently working on a two country model extended by a 3 equation NK model. The two countries have the same setup and are related with a UIP equation. However, the BK condition does not verified as the warning message hits. it usually happened with a timing line problem. I suspect there might be a problem lies in IS curve which augmented with nominal exchange rate gap, but can not figure it out. Does anyone can give me some idea?
Also attached with the model mod.

Best

Victor
Attachments
two_country_nk.mod
(9.5 KiB) Downloaded 48 times
zheyizhu
 
Posts: 2
Joined: Wed Jan 18, 2017 12:42 pm
Top

Re: two country model- BK condition not verified

Postby jpfeifer » Mon Jan 30, 2017 12:48 pm

Hard to tell. Have you looked at http://www.dynare.org/wp-repo/dynarewp029.pdf?
------------
Johannes Pfeifer
University of Cologne
https://sites.google.com/site/pfeiferecon/
jpfeifer
 
Posts: 6940
Joined: Sun Feb 21, 2010 4:02 pm
Location: Cologne, Germany
Top

Re: two country model- BK condition not verified

Postby zheyizhu » Tue Jan 31, 2017 11:34 am

Hi Johannes,

Thanks for your kindly advise. I would have a look then.

Best

Victor
zheyizhu
 
Posts: 2
Joined: Wed Jan 18, 2017 12:42 pm
Top
Topic locked

Return to Dynare help

Who is online

Users browsing this forum: No registered users and 9 guests

Powered by phpBB® Forum Software © phpBB Group