"isave" instead of save in Dynare produced .m file

[KarlWalentin]

The end of the .m file produced by Dynare states
"isave('modelname_results','oo_','dr_')"
instead of the usual "save(...)

an error msg "undefined function isave" then occurs when this line is run.

Any idea why this happens? I could clearly,by hand, take away the "i" in the .m-file every time, but it is a bit tedious.

Karl

[MichelJuillard]

Hi Karl,

can you send the *.mod file that produces that as well as details about
-Dynare version
-operating system

Since when do you observe the problem?

Kind regards

Michel

[KarlWalentin]

Michel,

Sorry for this question - I found the mistake myself: I had written the letter "i" on the very last line of the .mod file, after 3-4 empty lines. The preceeding line contained the stoch_simul command.

I used Dynare version 3.065 and Windows XP.