Is there anyone who has idea about how to insert exact values of certain variables at steady state into 'model' part? For example, in Taylor rule, we need to scale output by its s.s value (y/yss) in 'model' part but until we specify initval value and command "steady" to compute s.s , Dynare file does not have steady state value of y. My model is very sensitive to the ratio of y/ys so if I dont have exact value of ys, the results will change quite a bit.
Thank you very much in advance.
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Using steady state value in "model" part
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
1 post
• Page 1 of 1
Using steady state value in "model" part
by DV » Fri Dec 07, 2007 12:03 am
- DV
- Posts: 2
- Joined: Thu Dec 06, 2007 11:52 pm
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests