Dear all,
A very basic question: I ran a simulation of a RBC model, and I get in the "policy and transition functions" output values for variables written as
k(-1), k(-1)
or
k(-1), e
Not sure what they are? Products? Thank you so much, and best wishes, Jean-Paul
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Question about simulation output
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
1 post
• Page 1 of 1
Question about simulation output
by jlhuillier » Fri Dec 28, 2007 2:07 am
- jlhuillier
- Posts: 20
- Joined: Sat Dec 22, 2007 10:50 pm
- Location: Cambridge
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests