Hi,
When I run my model with Dynare the IRFs are displayed in two figures (one has the shock itself and 8 more variables; the 2nd figure only displays the output IRF) for each shock.
Does anyone know how to change the program so that the IRF of all variables are displayed in a single figure for each shock?
Best,
Joao
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
graphs
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
1 post
• Page 1 of 1
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests