hi all
is it possible to specify the initial values for the posterior optimiser to start with, in a separate vector, instead of using the syntax in the estimated_params section
tay_output_us,1.2 ,,, GAMMA_PDF,0.50,0.2500 ;
that is
can i give the 1.2 in a separate file or matrix?
reuben
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Specifying initial values for optimisation
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
1 post
• Page 1 of 1
Specifying initial values for optimisation
by reubenpjacob » Sat Mar 08, 2008 3:54 pm
- reubenpjacob
- Posts: 133
- Joined: Fri Oct 06, 2006 3:23 pm
- Location: Reserve Bank of New Zealand
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests