Hallo
I want to simulate the impact of a permanent shock.
Using Mathematica, I have calculated the initial and the new steady state.
I have then transfered the values into Dynare.
However, the dynare model with all the equations determining the transition, is not able to find the new steady state.
I have tried some alternatives:
1. implementing the new steady state values via the endval block
2. only using the shocks block and introducing the new value of the parameter to be shocked for the periods 1:t(with different values for t)
Both alternatives are not able to find the new steady state. Instead there is some kind of explosion.
I would be very grateful for comments!
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
permanent shock / no convergence
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
1 post
• Page 1 of 1
permanent shock / no convergence
by Frank » Thu Jul 24, 2008 9:01 pm
- Frank
- Posts: 1
- Joined: Mon Jun 23, 2008 1:52 pm
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 7 guests