Hi everyone,
I am trying to run a .mod file inside a loop (controlled from an .m file), changing some of the parameters during each iteration. In version 3 of Dynare, I used to save parameter values in a param.mat file, and then use a "load param.mat" command inside the .mod file instead of manually specifying parameter values.
However, this method is not working in Dynare 4.0.3; I get the statement that
"STEADY: numerical initial values incompatible with the following equations" and the list of all the model equations.
Obviously the "load" command isn't working. Is there a new way to load parameter values?
Thank you!
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Loading .mat files in Dynare 4.0.3
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
3 posts
• Page 1 of 1
Loading .mat files in Dynare 4.0.3
by olena7 » Fri Jun 12, 2009 7:02 pm
- olena7
- Posts: 18
- Joined: Wed Mar 25, 2009 8:28 pm
Re: Loading .mat files in Dynare 4.0.3
by StephaneAdjemian » Mon Jun 15, 2009 1:51 pm
- StephaneAdjemian
- Posts: 429
- Joined: Wed Jan 05, 2005 4:24 pm
- Location: Paris, France.
Re: Loading .mat files in Dynare 4.0.3
by olena7 » Mon Jun 15, 2009 2:34 pm
Stephane,
Thank you very much for the quick response. The file is now working.
Olena
Thank you very much for the quick response. The file is now working.
Olena
- olena7
- Posts: 18
- Joined: Wed Mar 25, 2009 8:28 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 13 guests