Hi,
One thing that I love about the C preprocessor is the ability to pass 'define' statements at the command line. '-Dmydefine' in the command line is equivalent to '#define mydefine' in the file.
Is there an equivalent in Dynare (or are there plans to)?
Thanks,
Gilles
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Macro processor
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Macro processor
by gbel » Mon Jun 14, 2010 2:16 pm
- gbel
- Posts: 33
- Joined: Thu Sep 04, 2008 8:34 pm
- Location: Québec
Re: Macro processor
by SébastienVillemot » Tue Jun 22, 2010 10:49 am
This feature is not available at the moment, and we have no immediate plans for that.
You can probably emulate it by writing some MATLAB code which dynamically creates a configuration file (containing only the defines) and to include that config file from your main MOD file.
You can probably emulate it by writing some MATLAB code which dynamically creates a configuration file (containing only the defines) and to include that config file from your main MOD file.
Sébastien Villemot
Economist at OFCE – Sciences Po
Economist at OFCE – Sciences Po
- SébastienVillemot
- Posts: 706
- Joined: Fri Dec 07, 2007 2:29 pm
- Location: Paris, France
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests