Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Calibrating SE of shocks
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Calibrating SE of shocks
by coot » Thu Jun 17, 2010 8:57 am
Hello. I would like to calibrate some stderr of some shocks and not estimate them. For this purpose should I use shocks block??
- coot
- Posts: 24
- Joined: Tue Apr 20, 2010 10:54 am
Re: Calibrating SE of shocks
by jpfeifer » Tue Jun 22, 2010 8:15 am
Yes, you should. If you specify the SE of an shock in the shocks block, Dynare takes this value as given in the estimation, if this SE is not included in the estimated_params block.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests