Page 1 of 1
Problem with Dynare 4
Posted:
Mon Jun 21, 2010 8:24 amby bamba
Dear dynare users,
Trying to run a model with a dynare 4, I encountered this following problem:
??? Undefined function or method 'dynare' for input arguments of type 'char'.
At the same time, I can runs the model in dynare 3
Cheers
Re: Problem with Dynare 4
Posted:
Tue Jun 22, 2010 8:12 amby jpfeifer
Hi,
clearly there is a problem with your installation of Dynare. Did you check that the program is correctly installed and that the installation path has been added to the Matlab paths?
Re: Problem with Dynare 4
Posted:
Tue Jun 22, 2010 8:50 amby bamba
Hi
i think Dynare 4 does not need to add the toolbox in "set path in matlab"; i have only to run the setup
i recall my model works with dynare 3 which is added in "set path in matlab"
Cheers
Re: Problem with Dynare 4
Posted:
Tue Jun 22, 2010 10:41 amby SébastienVillemot
You can’t have both Dynare 3 and Dynare 4 in the path at the same time.
Anyway, your problem is clearly caused by a problem with your Dynare installation; reinstall it and double check that your MATLAB path is clean and contain the “matlab” subdirectory of your Dynare 4 installation (and not any other Dynare directory).
Re: Problem with Dynare 4
Posted:
Tue Jun 22, 2010 11:19 amby bamba
Many thanks for your help
it is ok now
Cheers