Dynare fails to read my .mod file
Posted: Tue May 01, 2012 5:50 pmPlease help.
I have been trying several times to run a .mod file on octave but it returns as below:
octave:1> addpath c:\dynare\4.2.5\matlab
octave:2> dynare gilbert1
Configuring Dynare ...
[mex] Generalized QZ.
[mex] Sylvester equation solution.
[mex] Kronecker products.
[mex] Sparse kronecker products.
[mex] Bytecode evaluation.
[mex] k-order perturbation solver.
[mex] k-order solution simulation.
error: DYNARE: can't open gilbert1.mod
error: called from:
error: c:\dynare\4.2.5\matlab\dynare.m at line 96, column 5
octave:2>
I do not know what to do about this. The same problem occurs when i try on matlab. I'm frustrated.
Please help me.
Thank you
gilberto
I have been trying several times to run a .mod file on octave but it returns as below:
octave:1> addpath c:\dynare\4.2.5\matlab
octave:2> dynare gilbert1
Configuring Dynare ...
[mex] Generalized QZ.
[mex] Sylvester equation solution.
[mex] Kronecker products.
[mex] Sparse kronecker products.
[mex] Bytecode evaluation.
[mex] k-order perturbation solver.
[mex] k-order solution simulation.
error: DYNARE: can't open gilbert1.mod
error: called from:
error: c:\dynare\4.2.5\matlab\dynare.m at line 96, column 5
octave:2>
I do not know what to do about this. The same problem occurs when i try on matlab. I'm frustrated.
Please help me.
Thank you
gilberto