Please help.
I have been trying several times to run a .mod file on octave but it returns as below:
octave:1> addpath c:\dynare\4.2.5\matlab
octave:2> dynare gilbert1
Configuring Dynare ...
[mex] Generalized QZ.
[mex] Sylvester equation solution.
[mex] Kronecker products.
[mex] Sparse kronecker products.
[mex] Bytecode evaluation.
[mex] k-order perturbation solver.
[mex] k-order solution simulation.
error: DYNARE: can't open gilbert1.mod
error: called from:
error: c:\dynare\4.2.5\matlab\dynare.m at line 96, column 5
octave:2>
I do not know what to do about this. The same problem occurs when i try on matlab. I'm frustrated.
Please help me.
Thank you
gilberto
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Dynare fails to read my .mod file
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Dynare fails to read my .mod file
by gilberto » Tue May 01, 2012 5:50 pm
- gilberto
- Posts: 1
- Joined: Tue May 01, 2012 5:34 pm
Re: Dynare fails to read my .mod file
by kyri82 » Tue May 01, 2012 6:10 pm
Is the file in the active folder?
- kyri82
- Posts: 141
- Joined: Thu Feb 10, 2011 6:14 pm
- Location: Toulouse - France
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests