Source of test-file
Posted: Wed May 02, 2012 9:50 amHi everybode
I have two very short and one longer question:
1. In the manual it is reffered to the following example file, however, I have no clue where to download this: ‘./tests/smoother/calibrated_model.mod’ which is mentioned on page 45 of the file UserGuideDynare?
2. Where are the observed data saved in the estimation procedures of Dynare?
2. Does anybody have experience in using the shock decomposition provided by the attached file with a calibrated model rather than with an estimated model? Do you think it would be possible to just save the observed data and then running the shock decomposition or to use the code of 1 to simulate the estimation and then doing the shock decomposition?
I would highly appreciate an answer as soon as possible, thanks a lot in advance
Daniel
I have two very short and one longer question:
1. In the manual it is reffered to the following example file, however, I have no clue where to download this: ‘./tests/smoother/calibrated_model.mod’ which is mentioned on page 45 of the file UserGuideDynare?
2. Where are the observed data saved in the estimation procedures of Dynare?
2. Does anybody have experience in using the shock decomposition provided by the attached file with a calibrated model rather than with an estimated model? Do you think it would be possible to just save the observed data and then running the shock decomposition or to use the code of 1 to simulate the estimation and then doing the shock decomposition?
I would highly appreciate an answer as soon as possible, thanks a lot in advance
Daniel