Dynare forums

I use a MS-SVAR mod file as attached below to replicate it in dynare. however matlab shows such message as follows,could someone help me to figure out the problem?thanks

-----------------------------------------------------------------------------------------------------------------------------------------------
dynare DH10.mod;

Configuring Dynare ...
[mex] Generalized QZ.
[mex] Sylvester equation solution.
[mex] Kronecker products.
[mex] Sparse kronecker products.
[mex] Bytecode evaluation.
[mex] k-order perturbation solver.
[mex] k-order solution simulation.
[mex] Quasi Monte-Carlo sequence (Sobol).

Starting Dynare (version 2012-02-10).
Starting preprocessing of the model file ...
ERROR: DH10.mod:10.26-41: syntax error, unexpected NAME, expecting RESTRICTIONS or CHAIN or DURATION or NUMBER_OF_REGIMES

??? Error using ==> dynare
DYNARE: preprocessing failed

>>