Hi,
I am trying to run my mod file and I get the following error,
Configuring Dynare ...
[mex] Generalized QZ.
[mex] Sylvester equation solution.
[mex] Kronecker products.
[mex] Sparse kronecker products.
[mex] Bytecode evaluation.
[mex] k-order perturbation solver.
[mex] k-order solution simulation.
Starting Dynare (version 4.2.5).
Starting preprocessing of the model file ...
ERROR: MPFP.mod:6.12-104: Symbol r declared twice with different types!
??? Error using ==> dynare at 114
DYNARE: preprocessing failed
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Error message that says a variable r has been declared twice
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Error message that says a variable r has been declared twice
by lebeko » Mon Sep 10, 2012 12:43 pm
- Attachments
-
MPFP.mod- (2.07 KiB) Downloaded 142 times
- lebeko
- Posts: 3
- Joined: Mon Sep 10, 2012 12:33 pm
Re: Error message that says a variable r has been declared t
by vincent53nhl » Mon Sep 10, 2012 1:15 pm
1. In the 6th row, there should not be a space between 'rho_' and 'r';
2. There should be an 'end' before the 'initval' section, and you type the 'initval' wrong.
3. There are convergence problems, thus recheck the correctness of model and initial conditons again.
2. There should be an 'end' before the 'initval' section, and you type the 'initval' wrong.
3. There are convergence problems, thus recheck the correctness of model and initial conditons again.
- vincent53nhl
- Posts: 6
- Joined: Fri Apr 20, 2012 9:53 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests