Hi,
I am trying to use fmincon and (Matlab's) parallel computing toolbox to compute the mode.
I set mode_compute = 1 (to use fmincon) and optim = ('UseParallel','always') (to set fmincon's option) in the options of dynare's estimation command, but Matlab returns an error.
Is it possible to run fmincon in the parallel mode in dynare?
Thanks,
Takeki
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
fmincon and parallel computing toolbox in dynare
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
3 posts
• Page 1 of 1
fmincon and parallel computing toolbox in dynare
by takeki » Thu Jan 31, 2013 8:52 am
- takeki
- Posts: 2
- Joined: Sat Oct 08, 2005 12:36 pm
Re: fmincon and parallel computing toolbox in dynare
by SébastienVillemot » Wed Feb 13, 2013 11:30 am
We don't have MATLAB's parallel toolbox, so we can't answer your question. This is basically untested.
Sébastien Villemot
Economist at OFCE – Sciences Po
Economist at OFCE – Sciences Po
- SébastienVillemot
- Posts: 706
- Joined: Fri Dec 07, 2007 2:29 pm
- Location: Paris, France
Re: fmincon and parallel computing toolbox in dynare
by takeki » Tue Feb 19, 2013 2:33 pm
Thank you for the reply. I found that the use of global variables conflicts with the parallel computing toolbox.
I want to try to compute parameter values at the mode by myself, and feed them back into dynare in some way.
I want to try to compute parameter values at the mode by myself, and feed them back into dynare in some way.
- takeki
- Posts: 2
- Joined: Sat Oct 08, 2005 12:36 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 5 guests