The message came out when I run my model, what is code 37? Actually, what is info(1) and info(2) in the code means?
??? Error using ==> print_info
MJDGGES returns the following error code37
Error in ==> check at 21
print_info(info);
Error in ==> dht_inventory at 151
check;
Error in ==> dynare at 26
evalin('base',fname) ;
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
error code 37
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
error code 37
by bigbigben » Mon Jan 29, 2007 4:17 pm
- bigbigben
- Posts: 171
- Joined: Sun May 28, 2006 1:19 am
by MichelJuillard » Tue Jan 30, 2007 10:37 pm
This is an internal error code from Lapack. I believe it means that it couldn't compute the 37th generalized eigenvalue.
I very rarely see such errors. You may want to use Matlab debugger to look at D and E before the call to mjdgges in dr1.m
info(1) and info(2) are used by various functions to communicate to Dynare the reason for failure.
Best
Michel
I very rarely see such errors. You may want to use Matlab debugger to look at D and E before the call to mjdgges in dr1.m
info(1) and info(2) are used by various functions to communicate to Dynare the reason for failure.
Best
Michel
- MichelJuillard
- Posts: 680
- Joined: Thu Nov 18, 2004 10:51 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 10 guests