Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
parallel MCMC acceptation ratio=0.000
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
4 posts
• Page 1 of 1
parallel MCMC acceptation ratio=0.000
by kchristo » Fri Mar 08, 2013 5:45 pm
I am running dynare on linux (redhat) and MCMC works fine and I get plausible results. If I do the same thing in parallel mode I get an acceptation ratio of exactly zero for all blocks and later on close to singular matrices (compute_mh_covariance_matrix at 74 and amrginal_density at 54 and 67 ). The program contiunes until the end afterwards.
- kchristo
- Posts: 7
- Joined: Thu Jan 26, 2006 2:15 pm
Re: parallel MCMC acceptation ratio=0.000
by rattoma » Fri Mar 08, 2013 8:03 pm
Hi, could you post your dynare project?
thanks
thanks
- rattoma
- Posts: 51
- Joined: Tue Jan 04, 2005 10:48 am
Re: parallel MCMC acceptation ratio=0.000
by kchristo » Fri Mar 15, 2013 10:34 am
I found the mistake. I was using a steady state file using global variables. In the parallel environment this seems to have caused the confusion.
- kchristo
- Posts: 7
- Joined: Thu Jan 26, 2006 2:15 pm
Re: parallel MCMC acceptation ratio=0.000
by rattoma » Fri Mar 15, 2013 10:41 am
great, let me know of parallel MCMC works then
- rattoma
- Posts: 51
- Joined: Tue Jan 04, 2005 10:48 am
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 4 guests