Since the model in level just gives response of variable in level to one standard error error terms, I plan to draw some IRFs rescaled by the correponding steady state level. I used the variables generated by Dynare but it happens that those values is not the same as what is shown in figures generated by Dynare, some of them even have opposited signs.
You can check whether Inf_epsi1 is the same as that shown in figure: response to epsi1 and Interest Rate and Average hour.
That really drive me crazy. Can you explain why is the case.
I attached my mod file here.
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Plotting Problem by using Dynare
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Plotting Problem by using Dynare
by bigbigben » Wed Jan 31, 2007 5:08 pm
- Attachments
-
TSJH_try.mod- (8.5 KiB) Downloaded 91 times
- bigbigben
- Posts: 171
- Joined: Sun May 28, 2006 1:19 am
by MichelJuillard » Sun Feb 04, 2007 8:03 pm
This was indeed a bug in version 3 (not in version 4). I have corrected it and the correction will be available in the snapshot for version 3 from 02/05/07 on.
Thank you for reporting it.
Best
Michel
Thank you for reporting it.
Best
Michel
- MichelJuillard
- Posts: 680
- Joined: Thu Nov 18, 2004 10:51 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 10 guests