Hi everyone,
I have an basic question,
I am writing a model in non-linear form and let Dynare do the log-linearizing job. I am not sure how I should define a variable in "deviation form steady state value" value and another variable in "absolute deviation from 0".
Please help me out here.
thanks.
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
deviation from SS and absolute deviation from 0
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
deviation from SS and absolute deviation from 0
by marting » Sun Jul 21, 2013 4:21 pm
- marting
- Posts: 2
- Joined: Mon Jul 08, 2013 10:14 pm
Re: deviation from SS and absolute deviation from 0
by jpfeifer » Sun Jul 21, 2013 5:02 pm
You mean log-deviations vs. absolute deviations? The answer is: put all variables to be log-linearized (i.e. in percentage deviations from steady state) in exp() to perform a variable substitution, see http://www.dynare.org/phpBB3/viewtopic.php?f=1&t=4682. Variables in absoluted deviations from steady state are not put into exp()
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 7 guests