mode check
Posted: Fri Jun 27, 2014 2:51 amCould someone tell me if there is something wrong with the psi parameter mode check chart below ?
Thanks in advance.
Thanks in advance.
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
http://www.dynare.org/phpBB3/
mode check
Page 1 of 1
Posted: Fri Jun 27, 2014 2:51 amRe: mode check
Posted: Fri Jun 27, 2014 8:58 amIt looks weird, but it might just be numerical chatter as the scaling might be tiny. In that case, the parameter might be unidentified. Use the Data Cursor of the Matlab figure to find out about the scaling.