Dear all,
To me, the information in the log-file concerning the block ''Estimation::mcmc:' is somewhat confusing, since, apparently, it is valid per MH chain, not for all chains combined. That is, if it says:
Estimation::mcmc: Total number of MH draws: 500000.
Estimation::mcmc: Finally I keep 100000 draws.
that means that I have to multiply these numbers by the number of chains to get the absolute numbers. Maybe `draws' could be replaced by `draws per chain'.
gin
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
In log-file, 'Estimation::mcmc:' information
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
In log-file, 'Estimation::mcmc:' information
by gin » Mon Sep 15, 2014 3:14 pm
- gin
- Posts: 47
- Joined: Wed Feb 27, 2013 3:10 pm
- Location: Riga, Latvia
Re: In log-file, 'Estimation::mcmc:' information
by jpfeifer » Wed Sep 17, 2014 7:22 pm
Thanks. We are going to change this.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 11 guests