Dear all,
I am having trouble with locating the steady state of the enclosed model. It is particularly confusing since the analytical calculation of the steady state is given a nice exposition in ABC's of RBC's and I have simply put these values into the initval block. However, dynare reports that one of the equations has a residual of ~ 0.3. Any pointers for this beginner would be extremely appreciated.
Jake.
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Unable to find steady state!
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
3 posts
• Page 1 of 1
Unable to find steady state!
by jakegunner » Fri Oct 10, 2014 4:19 pm
- Attachments
-
hansens_rbc.mod- (692 Bytes) Downloaded 44 times
- jakegunner
- Posts: 5
- Joined: Fri Oct 10, 2014 3:40 pm
Re: Unable to find steady state!
by jpfeifer » Sat Oct 11, 2014 2:59 pm
I attached the corrected file. Your process for a was incorrectly specified and the timing for both the interest rate definition and for a were wrong.
- Attachments
-
- hansens_rbc.mod
- (700 Bytes) Downloaded 49 times
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
Re: Unable to find steady state!
by jakegunner » Sat Oct 11, 2014 6:05 pm
jpfeifer,
Thank you very much your help.
Thank you very much your help.
- jakegunner
- Posts: 5
- Joined: Fri Oct 10, 2014 3:40 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 13 guests