Page 1 of 1
why"model_diagnostics(M_,options_,oo_)"didn't work?
Posted:
Thu Oct 23, 2014 12:17 pmby Mandy
Hello all,
I used to type "model_diagnostics(M_,options_,oo_)" after running the model if it didn't run successfully.
However, in recent days, it shows nothing after I type "model_diagnostics(M_,options_,oo_)".
Is there something wrong with my Dynare??
Looking forward to your help.
Thanks in advance.
Re: why"model_diagnostics(M_,options_,oo_)"didn't work?
Posted:
Thu Oct 23, 2014 1:03 pmby jpfeifer
If you are using an older version of Dynare, if no obvious problems are detected, there is not output at all. Only more recent versions provide positive feedback.
Re: why"model_diagnostics(M_,options_,oo_)"didn't work?
Posted:
Fri Oct 24, 2014 1:47 amby Mandy
Hi jpfeifer,
You are very helpful. Thank you so much for helping us at this forum. I am truly grateful.
I am using Dynare 4.4.2. Do I need to update it?
If I don't need to, I don't want to because I am afraid of some other problems come out.
Thank you again.
Re: why"model_diagnostics(M_,options_,oo_)"didn't work?
Posted:
Fri Oct 24, 2014 8:07 amby jpfeifer
Unless you encounter one of the bugs noted at
http://www.dynare.org/DynareWiki/KnownBugs, there is no reason to upgrade. But I would always recommend using the latest stable version.
Re: why"model_diagnostics(M_,options_,oo_)"didn't work?
Posted:
Fri Oct 24, 2014 8:46 amby Mandy
OK,thank you for your help!