Page 1 of 1
??? Invalid MEX-file
Posted:
Fri Dec 19, 2014 3:54 pmby MSD
I am using dynare version 4.4.3. when I run the file, I receive this message:
"warning: Some of the parameters have no value when using stoch_simul. If these parameters are not initialized in a steady state file, Dynare may not be able to solve the model...
.
.
??? Invalid MEX-file
'c:\dynare\4.4.3\matlab\..\mex\matlab\win32-7.5-8.3\mjdgges.mexw32': The specified module could not be found."
Could anyone help to solve this please?
Re: ??? Invalid MEX-file
Posted:
Fri Dec 19, 2014 3:56 pmby jpfeifer
Try reinstalling Dynare 4.4.3. Did you install the correct MEX-file, i.e. the 32 or 64 bit version depending on your Windows OS.
Re: ??? Invalid MEX-file
Posted:
Fri Dec 19, 2014 4:59 pmby MSD
jpfeifer wrote:Try reinstalling Dynare 4.4.3. Did you install the correct MEX-file, i.e. the 32 or 64 bit version depending on your Windows OS.
Thanks for your reply. I'm a beginner. I have just installed "Dynare 4.4.3", my system is 32 bit but I am not sure about the MEX file! How can I check that?
Re: ??? Invalid MEX-file
Posted:
Fri Dec 19, 2014 5:11 pmby jpfeifer
Check whether the file
"c:\dynare\4.4.3\matlab\..\mex\matlab\win32-7.5-8.3\mjdgges.mexw32"
exists
Re: ??? Invalid MEX-file
Posted:
Fri Dec 19, 2014 6:08 pmby MSD
jpfeifer wrote:Check whether the file
"c:\dynare\4.4.3\matlab\..\mex\matlab\win32-7.5-8.3\mjdgges.mexw32"
exists
The content of this exists not in this directory but below:
"c:\dynare\4.4.3\mex\matlab\win32-7.5-8.3\mjdgges.mexw32"
Re: ??? Invalid MEX-file
Posted:
Sun Dec 28, 2014 10:04 amby jpfeifer
Strange, because everything looks correct and seems to be in place. Have you tried reinstalling Dynare or a different version of Dynare?