Hello,
in the attached code I am trying to compute impulse responses for a number of variables, including w, p and w/p. However, whilst the irf for w and p seem to suggest that the ratio should decrease upon impact (for the second shock in the model), the opposite is the case. I could not quite figure out why this is.
A little help would be much appreciated. Thank you very much in advance.
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
IRF Output
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
IRF Output
by faba » Thu Sep 03, 2015 8:32 pm
- Attachments
-
simple_model.mod- (2.46 KiB) Downloaded 121 times
- faba
- Posts: 1
- Joined: Thu Sep 03, 2015 8:29 pm
Re: IRF Output
by jpfeifer » Fri Sep 04, 2015 7:03 am
Run the numbers for w/p. They add up:
Second shock
(1.38042+0.001037)/(4.40631+0.002294)-(1.38042)/(4.40631)= 7.2206e-05
First shock
(1.38042-0.0007183)/(4.40631-0.01238)-(1.38042)/(4.40631) = 7.1921e-04
Second shock
(1.38042+0.001037)/(4.40631+0.002294)-(1.38042)/(4.40631)= 7.2206e-05
First shock
(1.38042-0.0007183)/(4.40631-0.01238)-(1.38042)/(4.40631) = 7.1921e-04
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 8 guests