Dear all,
I am trying to run the attached model with Dynare inside the Octave but I did not succeed.
It works good on Matlab but when I use the Octave the programm never returns me the results...
Does any one could help me?
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Problems with Octave
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Problems with Octave
by christiano_penna » Wed Nov 11, 2015 3:39 pm
- Attachments
-
Modelo_1.mod- (1.03 KiB) Downloaded 59 times
- christiano_penna
- Posts: 1
- Joined: Wed Nov 11, 2015 3:32 pm
Re: Problems with Octave
by jpfeifer » Wed Nov 11, 2015 3:56 pm
Which Dynare and Octave version are you using? Did you consider that Octave is a factor 2 to 10 slower than Matlab and you may need to wait longer?
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 12 guests