Dear Johannes,
Could you please look at my mode check plot and priors and posteriors plot?
I use mode_compute 4,6,9 to find mode until the log posterior density does not improve(keep unchanged) , however, rhoa (persistence of transitory technology shock) always reaches that large (0.997-0.998) after those several rounds of mode finding. And measurement error just a straight upwards line.
After I run the MCMC, rhoa and measurement error both hit the upper bond. And when I use mode_compute=9 to run MCMC, rhoa and measurement error do not converge, however when I use mode_compute= 4 or 6, all converge.
Could you give me any suggestions? Thanks a lot!
Catherine
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
prior and posterior
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
prior and posterior
by DW916 » Fri Mar 18, 2016 6:11 am
- Attachments
-
PriorsAndPosteriors1.pdf- (21.12 KiB) Downloaded 141 times
-
- CheckPlots.pdf
- (11.53 KiB) Downloaded 120 times
- DW916
- Posts: 31
- Joined: Sat Feb 27, 2016 9:05 am
Re: prior and posterior
by jpfeifer » Fri Mar 18, 2016 8:28 am
Given that both rhoa and rhop go to 1 I would think your observation equation is still wrong, usually a constant term that is not accounted for.
Regarding measurement error: try what happens when you lift the upper bound.
Regarding measurement error: try what happens when you lift the upper bound.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 14 guests