Page 1 of 1
Clean up the directory
Posted:
Thu Sep 04, 2008 9:05 pmby gbel
Hi,
These three files clean the '.pdf', '.eps' and '.fig' files created by Dynare replacing them with one '.pdf' file with all the graphs in it. It add a title on each page to avoid confusion.
Two of the '.m' files were taken from the Internet, the other is mine.
Just put: 'dyngraph;' at the end of your '.mod' file or type 'dyngraph' right after running Dynare
Hope you like,
Gilles
Posted:
Thu Sep 11, 2008 2:47 pmby gbel
This is a better version of 'dyngraph.m'
It works with estimations and there was one small bugfix.
Re: Clean up the directory
Posted:
Wed Feb 25, 2009 5:53 pmby roberto.croce
Very helpful. The number of files in my working folders gets totally out of hand. This is great, thank you.
Re: Clean up the directory
Posted:
Thu Feb 04, 2010 8:12 pmby cyepez
This is helpful. thanks!
Re: Clean up the directory
Posted:
Sat Feb 06, 2010 9:49 pmby jonathanb
Very very helpful.
Re: Clean up the directory
Posted:
Mon Oct 31, 2011 3:12 pmby donihue
Hello Gilles,
I have been using your wonderful "dyngraph" programme for some time, and it always works a charm. Thanks so much for this excellent initiative!
Just now, I tested it when using Dynare with Octave, rather than Matlab, and it fails, ostensibly because Octave cannot find a "DairyFile", but probably because there are differences between Octave and Matlab. Do you by any chance have a version of dyngraph which works with Octave? (My students cannot afford Matlab!)
Many thanks and best regards
Donihue
Re: Clean up the directory
Posted:
Thu Nov 10, 2011 8:00 pmby gbel
Hi Donihue,
I'll take a look as soon as I have time,
Gilles