4.6 Auxiliary variables

The model which is solved internally by Dynare is not exactly the model declared by the user. In some cases, Dynare will introduce auxiliary endogenous variables—along with corresponding auxiliary equations—which will appear in the final output.

The main transformation concerns leads and lags. Dynare will perform a transformation of the model so that there is only one lead and one lag on endogenous variables and, in the case of a stochastic model, no leads/lags on exogenous variables.

This transformation is achieved by the creation of auxiliary variables and corresponding equations. For example, if x(+2) exists in the model, Dynare will create one auxiliary variable AUX_ENDO_LEAD = x(+1), and replace x(+2) by AUX_ENDO_LEAD(+1).

A similar transformation is done for lags greater than 2 on endogenous (auxiliary variables will have a name beginning with AUX_ENDO_LAG), and for exogenous with leads and lags (auxiliary variables will have a name beginning with AUX_EXO_LEAD or AUX_EXO_LAG respectively).

Another transformation is done for the EXPECTATION operator. For each occurrence of this operator, Dynare creates an auxiliary variable defined by a new equation, and replaces the expectation operator by a reference to the new auxiliary variable. For example, the expression EXPECTATION(-1)(x(+1)) is replaced by AUX_EXPECT_LAG_1(-1), and the new auxiliary variable is declared as AUX_EXPECT_LAG_1 = x(+2).

Auxiliary variables are also introduced by the preprocessor for the ramsey_model and ramsey_policy commands. In this case, they are used to represent the Lagrange multipliers when first order conditions of the Ramsey problem are computed. The new variables take the form MULT_i, where i represents the constraint with which the multiplier is associated (counted from the order of declaration in the model block).

The last type of auxiliary variables is introduced by the differentiate_forward_vars option of the model block. The new variables take the form AUX_DIFF_FWRD_i, and are equal to x-x(-1) for some endogenous variable x.

Once created, all auxiliary variables are included in the set of endogenous variables. The output of decision rules (see below) is such that auxiliary variable names are replaced by the original variables they refer to.

The number of endogenous variables before the creation of auxiliary variables is stored in M_.orig_endo_nbr, and the number of endogenous variables after the creation of auxiliary variables is stored in M_.endo_nbr.

See Dynare Wiki for more technical details on auxiliary variables.

This document was generated by Stéphane Adjemian on June 11, 2017 using texi2html 1.82.