Hi everyone,
please, is there any problem with a portability between Dynare in MATLAB and in Octave? Are these two perfectly compatible? The problem is that I will obtain a .mod file prepared in Dynare for MATLAB and I plan to run it in Dynare for Octave.
Thanks in advance.
Jan
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Dynare in MATLAB vs. Octave
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Dynare in MATLAB vs. Octave
by Jan » Thu Mar 16, 2017 1:55 pm
- Jan
- Posts: 5
- Joined: Tue Mar 15, 2016 12:31 pm
Re: Dynare in MATLAB vs. Octave
by jpfeifer » Thu Mar 16, 2017 5:01 pm
I guess you are talking about Windows? If you have a matching version of Dynare and Octave on Windows, then compatibility is very good (except for some solvers only being available in Matlab Toolboxes). Problems arise if you use an Octave version newer than what Dynare currently supports. Ideally, you should use 4.4.3 with Octave 3.8.1
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 7 guests