Dear all,
I'm very new with Dynare. After reading installation, I would like to try to do as the manual said. However, I had a problem with the first command of 'var' which is for setting the variables. But this command is the same of 'var' for calculating the variace. Thus, I can't run dynare. Any help from you would be greatly appreciated.
Best,Pisut
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
'var' command
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
3 posts
• Page 1 of 1
'var' command
by tung_1976 » Fri Aug 21, 2009 6:41 am
- tung_1976
- Posts: 4
- Joined: Fri Aug 21, 2009 6:33 am
Re: 'var' command
by SébastienVillemot » Mon Aug 24, 2009 1:02 pm
Hi,
The 'var' keyword has indeed two meanings: it can declare endogenous or it can be used for shock variances.
However, Dynare is able to distinguish between the two, given the context. So you should not encounter an error.
Please post your MOD file if you want more help.
Best,
S.V.
The 'var' keyword has indeed two meanings: it can declare endogenous or it can be used for shock variances.
However, Dynare is able to distinguish between the two, given the context. So you should not encounter an error.
Please post your MOD file if you want more help.
Best,
S.V.
Sébastien Villemot
Economist at OFCE – Sciences Po
Economist at OFCE – Sciences Po
- SébastienVillemot
- Posts: 706
- Joined: Fri Dec 07, 2007 2:29 pm
- Location: Paris, France
Re: 'var' command
by tung_1976 » Tue Aug 25, 2009 4:56 pm
Thank you for your suggestion. I wrote the mod file with matlab editor. I might go back to check installation guide again.
- tung_1976
- Posts: 4
- Joined: Fri Aug 21, 2009 6:33 am
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 15 guests