My code for simulation goes well.and i input ''resid(1)'' after simulation ,results as follows comes out:
Residuals of the static equations:
Equation number 1 : 0
Equation number 2 : 0
Equation number 3 : 0
Equation number 4 : 0
Equation number 5 : 0
Equation number 6 : 0
Equation number 7 : 0
Equation number 8 : 0
Equation number 9 : 0
Equation number 10 : 0
Equation number 11 : 0
Equation number 12 : 0
Equation number 13 : 0
Equation number 14 : 0
Equation number 15 : 0
Equation number 16 : 0
Equation number 17 : 0
Equation number 18 : 0
ans =
1.0e-15 *
0
0
0
0
0
0.1110
0
0
-0.4441
-0.1665
0.0555
0
0
0
0
0
-0.2220
0
The version of my dynare is 4.3.2 The up side of this result is 0, but the bottom side says no .whis this mean?(I know few about MATLAB)
Thank you for your time.
Best
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
the problems about residual
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
the problems about residual
by jinyou_yin » Sat Apr 06, 2013 12:33 pm
- jinyou_yin
- Posts: 11
- Joined: Sun Mar 10, 2013 2:17 am
Re: the problems about residual
by jpfeifer » Tue Apr 09, 2013 8:11 am
This is due to numerical rounding. Everything that is 0 to the last 10 decimals or so is taken to be 0.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 7 guests