I'm trying to use load_mh_file with mh_replic=0 in order to do some post estimation analysis like simulate the model at the posterior mean and do variance decomposition but if I run the mod file with those options dynare does not load the results from the previous MCMC draws but just the results found in the first stage. Any suggestion on how to load the full MCMC results without having to do anymore draws?
Thanks
Cristiano
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Load MCMC results without adding anymore draws
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Load MCMC results without adding anymore draws
by c_cantore » Mon Jun 17, 2013 3:14 pm
- c_cantore
- Posts: 1
- Joined: Mon Jun 17, 2013 3:10 pm
Re: Load MCMC results without adding anymore draws
by ncjoe » Fri Jul 19, 2013 8:30 am
Hi,
I face the same problem. Do you figure out how to achieve it? If so, please kindly share me your experience.
Best,
ncjoe
I face the same problem. Do you figure out how to achieve it? If so, please kindly share me your experience.
Best,
ncjoe
- ncjoe
- Posts: 1
- Joined: Fri Jul 19, 2013 8:24 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 8 guests