Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Small Residual but Not Converging
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
1 post
• Page 1 of 1
Small Residual but Not Converging
by jgrav » Mon Oct 28, 2013 1:28 pm
I am attempting to simulate a model with 36 equations. I used the initval command, followed by some values, and then the steady command. For 34 of the equations, the residual is 0. For the other two, one is less than .0008 and the other is about -3e-5. Why is it still telling me that it can't find the steady state? Is it possible to fix/get around this?
- jgrav
- Posts: 9
- Joined: Wed Oct 02, 2013 12:17 am
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests