Problem with RBC_Est.mod

This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location where you will have to reset your password.
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.

Problem with RBC_Est.mod

Postby romitam » Sat Jul 03, 2010 11:41 pm

Hi,

I do not know if this is a more general problem. I was trying to estimate the parameters of a DSGE model. When I tried stoch_simul with a given set of initial values it worked fine. Later when I used those values for estimation and used the command "steady" an error showed up. But it ran fine when I removed the steady command.

Then I tried this out with the file RBC_Est.mod. If I put the command steady after the initval command then it gives an error. It runs fine without the steady command. It would be great if you could check this out.

Regards and thanks.
romitam
 
Posts: 2
Joined: Thu Jul 01, 2010 9:21 pm

Re: Problem with RBC_Est.mod

Postby Malia98653 » Wed Nov 20, 2013 7:54 am

Thanks for sharing.
Malia98653
 
Posts: 1
Joined: Wed Nov 20, 2013 7:51 am


Return to Dynare User Guide

Who is online

Users browsing this forum: No registered users and 0 guests