Dear all,
I am estimating a linearized model using the pound operator (#) for some parameters. Where does Dynare store those parameters (updated once the estimation is done)? If for example #gamma = 1 + ctrend/100, where can I read the updated value of gamma?
Thanks in advance for your help.
Lara
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
where does Dynare store parameters with the pound operator?
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
where does Dynare store parameters with the pound operator?
by Lara » Sun Feb 02, 2014 6:43 pm
- Lara
- Posts: 33
- Joined: Tue Jan 19, 2010 7:11 pm
Re: where does Dynare store parameters with the pound operat
by jpfeifer » Sun Feb 02, 2014 7:42 pm
Dynare does not store it at all. Given the estimated parameters, you would have to compute it using the specified formula. The reason for not storing it is that this would be redundant as the defined expression is not an independent parameter.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests