Hi,
I am trying to solve a NK model in Dynare. I was wondering if it's possible to call one of the parameter values from a matlab file, or loop over a parameter value? I basically need to be able to look at the change in the volatility of variables as a certain parameter changes, and ideally I would like to be able to save these volatilities and draw a graph against the parameter value. Since the parameter will take many values, I obviously can't write a different dynare code for each of them.
Is this possible with dynare or should I solve my model in matlab?
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Looping over parameter value/entering value from matlab
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
3 posts
• Page 1 of 1
Looping over parameter value/entering value from matlab
by miga_7 » Fri May 30, 2014 6:32 pm
- miga_7
- Posts: 13
- Joined: Fri May 30, 2014 6:23 pm
Re: Looping over parameter value/entering value from matlab
by jpfeifer » Sat May 31, 2014 6:05 am
That is quite easily doable: http://www.dynare.org/phpBB3/viewtopic.php?f=1&t=4891
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
Re: Looping over parameter value/entering value from matlab
by miga_7 » Mon Jun 09, 2014 1:41 pm
ok, thanks. That helps a lot. Sorry for the late reply, I was off working on the model!
- miga_7
- Posts: 13
- Joined: Fri May 30, 2014 6:23 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 5 guests