Could someone tell me if there is something wrong with the psi parameter mode check chart below ?
Thanks in advance.
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
mode check
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Re: mode check
by jpfeifer » Fri Jun 27, 2014 8:58 am
It looks weird, but it might just be numerical chatter as the scaling might be tiny. In that case, the parameter might be unidentified. Use the Data Cursor of the Matlab figure to find out about the scaling.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests