Dear all,
I run a MCMC with 1 million draws and after that find that the order of autocorrelation coefficients is not enough. Is there a convenient way in Dynare to recalculate the autocorrelation coefficients based on the draws I already have? I don't want to run the MCMC again.
Thanks in advance!
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
A question on post-MCMC calculations
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
3 posts
• Page 1 of 1
A question on post-MCMC calculations
by Econbee » Wed Oct 15, 2014 3:19 pm
- Econbee
- Posts: 74
- Joined: Fri Nov 08, 2013 8:14 am
Re: A question on post-MCMC calculations
by jpfeifer » Thu Oct 16, 2014 9:37 am
It should be possible to use the load_mh_file option. But be careful and save a copy of your whole folder before playing around with it.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
Re: A question on post-MCMC calculations
by Econbee » Thu Oct 16, 2014 1:19 pm
I see. Thank you, Dear Johannes!
- Econbee
- Posts: 74
- Joined: Fri Nov 08, 2013 8:14 am
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 7 guests