Hello,
I am working on the attached model (here expressed as 2nd order approximated) but I am facing some problem with the 3rd order approximation technique.
In particular, as displayed at page 47 of Dynare 4.4.2 manual, launching the program using stoch_simul(order=3), Matlab will work on a model expanded using Taylor procedure as illustrated by the formula:
yt = ys + G0 + G1zt + G2(zt * zt) + G3(zt * zt * zt)
Once calculated, I would like to display every single matrix of the above formula but I just don’t know how, can anyone indicate a way to do that?
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
3rd order approximation
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
3rd order approximation
by Nemo4t » Tue Nov 11, 2014 7:35 pm
- Attachments
-
RBClevels2ndDynare.mod- (588 Bytes) Downloaded 48 times
- Nemo4t
- Posts: 9
- Joined: Thu Nov 06, 2014 10:55 am
Re: 3rd order approximation
by jpfeifer » Wed Nov 12, 2014 8:38 pm
They are stored in oo_.dr as documented in the manual. Take a look into the simult_.m function (at the end of it) to see how the matrices are used.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 7 guests