Dear Dynare team,
I have a question concerning the Interpretation of identification alanysis graph in Dynare. Particularly, what does it mean when for some parameters both blue and yellow bars are in the negative range?
Dynare says that all paramters are identified.
Thanks a lot!
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Identification strength
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Identification strength
by student23 » Tue May 12, 2015 8:46 am
- student23
- Posts: 2
- Joined: Sun May 10, 2015 9:19 pm
Re: Identification strength
by jpfeifer » Fri May 15, 2015 9:28 am
Please take a look at Pfeifer (2014): An Introduction to Graphs in Dynare at https://sites.google.com/site/pfeiferecon/dynare. Basically deviations from 0 show the identification strength. Only 0 would be a problem.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 6 guests