the maxstepsize value in the climbing the hill process fall in zero
however the current MH acceptance ratio for the first and second block was respectively 0.27 and 0.28
what does it mean?
best
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
maxstepsize
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
3 posts
• Page 1 of 1
maxstepsize
by Ravelomanana » Mon Jun 08, 2015 4:12 pm
- Ravelomanana
- Posts: 17
- Joined: Mon May 11, 2015 5:49 pm
Re: maxstepsize
by jpfeifer » Tue Jun 09, 2015 8:37 am
Please provide an example to replicate the issue.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
Re: maxstepsize
by Ravelomanana » Tue Jun 09, 2015 1:32 pm
even the process did not go at the end. I guess the maxstepsize is about 0.0000 meaning around zero. and the MH acceptance rate was as I said above. In the matlab window some red warning message saying Matrix is singular ...badly scaled...something like this..
does it mean that the prior mean give any information to the data or what?
or the observation equations are not well specified or I have to add more observation?
does it mean that the prior mean give any information to the data or what?
or the observation equations are not well specified or I have to add more observation?
- Ravelomanana
- Posts: 17
- Joined: Mon May 11, 2015 5:49 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 9 guests