Hello,
I have read the forum postings for the Mode Check Plots, and my understanding is that these plots give insight on whether a parameter is identifiable from the data. If the log-lik kernel line is flat in the horizonal direction then the parameter is not identified from the data. Hence, the estimate value maybe questionable.
Is my understanding correct?
When I am interpreting the plots how should one reason about the curvature match or difference of the log-lik kernel and log-post line?
Example in the attached file the comOpenness curves match pretty well. Whereas, Alpha1, eta theta are not good matches.
How should interpret the difference between an upward and downward sloping log-lik kernel line?
For instance zeta vs eta.
Lastly, what do the red dots represent?
Any insight would be greatly appreciated and thank you in advance.
Regards,
Richard
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Mode Check Plots Curvature
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Mode Check Plots Curvature
by rwhitt01 » Tue Jun 09, 2015 7:55 pm
- Attachments
-
Check_Mode_plots.png.zip- (36.83 KiB) Downloaded 286 times
- rwhitt01
- Posts: 23
- Joined: Tue Nov 11, 2014 5:50 pm
Re: Mode Check Plots Curvature
by jpfeifer » Wed Jun 10, 2015 5:32 am
Please see Pfeifer (2014): An Introduction to Graphs in Dynare at https://sites.google.com/site/pfeiferecon/dynare
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 9 guests