Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Setting parameter and initial values frome matlab.
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Setting parameter and initial values frome matlab.
by mehrdad-t » Sat Oct 03, 2015 7:00 pm
I need to run the simulation many times for different values of parameters and initial values. How can I set the variables of a .mod file from matlab.
- mehrdad-t
- Posts: 1
- Joined: Sat Oct 03, 2015 6:26 pm
Re: Setting parameter and initial values frome matlab.
by jpfeifer » Sun Oct 04, 2015 10:03 am
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests