Hi,
When I write the stoch_simul command, what is the difference between specifying periods=1000 as opposed to not specifying this? Is the simulation stochastic in both cases? Also what is the meaning of incorporating hp_filter=100 in the soch_simul command as in
stoch_simul(order=1,hp_filter=100,irf=40).
Answers will be greatly helpful.
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Stochastic Simulation
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
3 posts
• Page 1 of 1
Stochastic Simulation
by pbrr25 » Mon Oct 05, 2015 4:10 am
- pbrr25
- Posts: 4
- Joined: Sun Aug 17, 2014 9:54 am
Re: Stochastic Simulation
by jpfeifer » Mon Oct 05, 2015 5:54 am
For the periods statement, see http://www.dynare.org/phpBB3/viewtopic.php?f=1&t=6716
The hp_filter=100 option tells Dynare to use an HP filter with the smoothing parameter set to 100 (which is unusual). The displayed moments will then be the ones of the filtered variables.
The hp_filter=100 option tells Dynare to use an HP filter with the smoothing parameter set to 100 (which is unusual). The displayed moments will then be the ones of the filtered variables.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests