Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
where are the parameters of policy functions stored?
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
3 posts
• Page 1 of 1
where are the parameters of policy functions stored?
by fuyangzhao » Thu Dec 10, 2015 3:24 pm
After running the mod file, the tabular result reports various information, including the policy and transition functions. I want to know where are the policy and transition functions stored. I looked for them all over the workspace in MatLab but couldn't find them. Where can I find these parameters?
- fuyangzhao
- Posts: 48
- Joined: Thu Dec 10, 2015 1:20 pm
Re: where are the parameters of policy functions stored?
by jpfeifer » Thu Dec 10, 2015 3:41 pm
See Section "4.13.3 First order approximation" of the Dynare manual, e.g. here http://www.dynare.org/manual/index_26.html
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
Re: where are the parameters of policy functions stored?
by fuyangzhao » Fri Dec 11, 2015 1:38 am
Thanks!!!
jpfeifer wrote:See Section "4.13.3 First order approximation" of the Dynare manual, e.g. here http://www.dynare.org/manual/index_26.html
- fuyangzhao
- Posts: 48
- Joined: Thu Dec 10, 2015 1:20 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 8 guests